GS 350 RWD V6-3.5L (2GR-FSE) (2007)
Camber, caster and steering axis inclination 2GR-FSE
Camber, caster and steering axis inclination 3UZ-FE
NOTICE:
^
Inspect while the vehicle is empty.
^
The maximum tolerance of right and left difference for the camber and caster is 30' (0.5°) or less.
(e)
Remove the camber-caster-steering axis inclination gauge and attachment.
(f)
Install the center ornament.
If the caster and steering axis inclination are not within the specified values, after the camber has been correctly adjusted, recheck the
suspension parts for damaged and/or worn out parts.
7. INSPECT FRONT SUSPENSION (for 2WD)
(a)
Inspect the front suspension member.
(1) Measure the dimension between the center of the installation bolts of the front suspension lower arm.
Standard: 692.5 to 699.5 mm (27.26 to 27.54 in.)
If the result is not within the specification, replace the front suspension member.