GS 350 RWD V6-3.5L (2GR-FSE) (2007)
(c)
If it is difficult to install the V-ribbed belt, perform the following procedure.
(1) Put the V-ribbed belt on every part except the tensioner pulley as shown in the illustration.
(2) While releasing the belt tension by turning the belt tensioner counterclockwise, put the V-ribbed belt on the tensioner pulley.
NOTICE:
^
Put the backside of the V-ribbed belt on the tensioner pulley and idler pulley.
^
Check that the V-ribbed belt is properly set to each pulley.
2. INSTALL NO. 1 AIR CLEANER INLET
(a)
Install the air cleaner inlet with the bolt.
Torque: 5.0 N*m (51 kgf*cm, 44 in.*lbf)
3. INSTALL V-BANK COVER SUB-ASSEMBLY
4. INSTALL COOL AIR INTAKE DUCT SEAL