GS 350 RWD V6-3.5L (2GR-FSE) (2007)
Standard resistance
(b) Connect the positive (+) lead to the terminal of the solenoid connector, and the negative (-) lead to the solenoid body, and check operation of
the valve.
NOTICE: While using the battery during inspection, do not bring the positive and negative tester probes too close to each other as a short
circuit may occur.
OK: The solenoid makes an operating sound.
3. INSPECT SHIFT SOLENOID VALVE (S2)
(a)
Measure the resistance according to the value(s) in the table.
Standard resistance
(b) Connect the positive (+) lead to the terminal of the solenoid connector, and the negative (-) lead to the solenoid body, and check operation of
the valve.
NOTICE: While using the battery during inspection, do not bring the positive and negative tester probes too close to each other as a short
circuit may occur.
OK: The solenoid makes an operating sound.
4. INSPECT SHIFT SOLENOID VALVE (S3)
(a)
Measure the resistance according to the value(s) in the table.