GX 470 V8-4.7L (2UZ-FE) (2004)
p. Uniformly tighten the 22 bearing cap bolts in several passes, in the sequence shown.
Torque:
Bolt C 7.5 Nm (80 kgf-cm, 66 inch lbs.)
Others 16 Nm (160 kgf-cm, 12 ft. lbs.)
q. Boring the service bolt installed in the driven sub-gear upward by turning the hexagon wrench head portion of the camshaft with a wrench.
r.
Remove the service bolt.
11. INSPECT VALVE CLEARANCE
12. INSTALL SEMICIRCULAR PLUG
a. Remove any old packing (FIPG) material.
b. Apply seal packing to the semi-circular plug grooves.
Seal packing:
Part No. 08826-00080 or equivalent
c. Install the 2 semi-circular plugs to the cylinder heads.
13. INSTALL CYLINDER HEAD COVER
a. Remove any old packing (FIPG) material.
b. Apply seal packing to the cylinder heads as shown in the illustration.
Seal packing: Part No. 08826-00080 or equivalent
c. Install the gasket to the cylinder head cover.
d. Install the seal washer to the bolt.
e. Install the cylinder head cover with the 18 bolts. Uniformly tighten the bolts in several passes. Install the 2 cylinder head covers.
Torque: 6.0 Nm (60 kgf-cm, 53 inch lbs.)
14. INSTALL IGNITION COIL ASSY
a. Install 4 bolts and ignition coil assy..
Torque: 7.5 Nm (80 kgf-cm, 66 inch lbs.)