GX 470 V8-4.7L (2UZ-FE) (2004)
/Page-450006.png)
k. Install the front bearing cap.
HINT: Installing the front bearing cap will determine the thrust portion of the camshaft.
l.
Install the other bearing cap in the sequence shown with the arrow mark facing forward.
HINT: Align the arrow marks at the front and rear of the cylinder head with the mark on the bearing cap.
m. Push in the new camshaft oil seal.
n. Apply a light coat of engine oil on the threads and under the heads (D and E) of the bearing cap bolts.
HINT: Do not apply engine oil under the heads of the bearing cap bolt (A), (B) and (C).
o. Install the oil feed pipe and the 22 bearing cap bolts as shown.
HINT: Each bolt length is indicated in the illustration.
Bolt length:
94 mm (3.70 inch) for A
72 mm (2.83 inch) for B
25 mm (0.98 inch) for C
52 mm (2.05 inch) for D
38 mm (1.50 inch) for E
