HS 250h L4-2.4L (2AZ-FXE) Hybrid (2010)
Torque : 8.0 Nm (82 kgf-cm, 71 in-lbf)
(b) Install the battery cover lock striker, then push the button to lock it.
(c) Connect the frame wire and install the nut.
Torque : 9.0 Nm (92 kgf-cm, 80 in-lbf)
(d) Install the nut and connect the ground cable.
Torque : 8.0 Nm (82 kgf-cm, 71 in-lbf)
5. CONNECT CABLE TO BATTERY TERMINAL
(a) Install the nut and clamp.
Torque : 7.6 Nm (77 kgf-cm, 67 in-lbf)
(b) Install the terminal cover.
6. INSTALL REAR SEATBACK ASSEMBLY
HINT
See: Body and Frame/Seats/Service and Repair/Removal and Replacement/Rear Seat Assembly/Installation.
7. INSTALL REAR FLOOR SIDE MEMBER COVER RH
(a) Install the rear floor side member cover RH with the 2 bolts and 2 clips.
8. INSTALL FRONT CENTER FLOOR COVER RH
(a) Install the front center floor cover RH with the 3 clips.
9. INSTALL FRONT FLOOR COVER RH
(a) Install the front floor cover RH with the bolt and 4 clips.
10. INSTALL INTAKE MANIFOLD
HINT
See: Engine, Cooling and Exhaust/Engine/Intake Manifold/Service and Repair/Installation.
11. INSTALL INVERTER WITH CONVERTER ASSEMBLY
HINT
See: Power Control System/Voltage Converter/Service and Repair/Inverter With Converter/Installation.