HS 250h L4-2.4L (2AZ-FXE) Hybrid (2010)
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Text in Illustration
NG -- REPAIR OR REPLACE CAN BUS BRANCH WIRE OR CONNECTOR (CAN NO. 1 J/C - DRIVING SUPPORT ECU)
OK -- Continue to next step.
6. CHECK FOR SHORT IN CAN BUS WIRES (CAN NO. 1 J/C - SEAT BELT CONTROL ECU)
HINT
For vehicles without the pre-collision system, go to the next step.
(a) Disconnect the seat belt control ECU connector.
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Text in Illustration
NG -- REPAIR OR REPLACE CAN BUS BRANCH WIRE OR CONNECTOR (CAN NO. 1 J/C - SEAT BELT CONTROL
ECU)
OK -- Continue to next step.
7. CHECK FOR SHORT IN CAN BUS WIRES (CAN NO. 1 J/C - CERTIFICATION ECU)
(a) Disconnect the smart key ECU (certification ECU) connector.