HS 250h L4-2.4L (2AZ-FXE) Hybrid (2010)
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Result:
C -- REPAIR OR REPLACE CAN BRANCH WIRE CONNECTED TO DLC3
B -- CHECK FOR SHORT IN CAN BUS WIRES (CAN NO. 1 J/C - CAN J/C LH)
A -- Continue to next step.
4. CHECK FOR SHORT IN CAN BUS WIRES (CAN NO. 1 J/C - CAN J/C RH)
(a) Disconnect the wire harness connector from the CAN No. 1 junction connector lower side.
Text in Illustration
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
NG -- CHECK FOR SHORT IN CAN BUS WIRES (CAN J/C RH - CAN NO. 1 J/C, COMBINATION METER)
OK -- Continue to next step.
5. CHECK FOR SHORT IN CAN BUS WIRES (CAN NO. 1 J/C - DRIVING SUPPORT ECU)
HINT
For vehicles without the dynamic radar cruise control system, go to the next step.
(a) Disconnect the driving support ECU connector.