IS 250 AWD V6-2.5L (4GR-FSE) (2006)
c. Clamp SST (A) in a vise.
d. Place the rotor shaft end into SST (A).
e. Fit SST (B) to the clutch pulley.
f.
Tighten the pulley by turning SST (B) in the direction shown in the illustration.
Torque: 111 N.m (1,127 kgf.cm, 81 ft.lbf)
NOTE: The torque should be used for tightening without using SST. When the SST is used for tightening, the torque should be calculated
based on the length of the SST.
g. Remove the generator assembly from the SST.
h. Check that the clutch pulley rotates smoothly.
i.
Install the new clutch pulley cap to the clutch pulley.