IS 250 AWD V6-2.5L (4GR-FSE) (2006)
NOTICE: Be careful not to drop the inboard joint assembly.
10. REMOVE FRONT DRIVE SHAFT BEARING (for RH Side)
a) Using a snap ring expander, remove the drive shaft bearing snap ring.
b) Using SST and a press, remove the bearing.
SST 09527-10011
NOTICE: Be careful not to drop the inboard joint assembly.
11. REMOVE NO.1 FRONT WHEEL BEARING DUST DEFLECTOR
a) Using a screwdriver and hammer, remove the No.1 front wheel bearing dust deflector.
INSPECTION
1. INSPECT FRONT DRIVE SHAFT ASSEMBLY
a) Check that there is no excessive play in the outboard joint.
b) Check that the inboard joint slides smoothly in the thrust direction.
c) Check that there is no excessive play in the radial directions of the inboard joint.
d) Check the boot for damage.