IS 250C V6-2.5L (4GR-FSE) (2011)
Seat Belt: Testing and Inspection
Rear Seat Outer Belt Assembly
SEAT BELT: REAR SEAT OUTER BELT ASSEMBLY: ON-VEHICLE INSPECTION
CAUTION:
Be sure to follow the correct removal and installation procedures of the rear seat 3 point type inner belt assembly.
1. INSPECT REAR SEAT 3 POINT TYPE INNER BELT ASSEMBLY (for Vehicle not Involved in Collision)
(a) Perform a diagnostic system check See: Air Bag Systems/Testing and Inspection/Reading and Clearing Diagnostic Trouble Codes.
(b) Visually check for defects with the rear seat 3 point type inner belt assembly installed on the vehicle.
(1) The defects are as follows:
Cuts on the rear seat 3 point type inner belt assembly
Small cracks on the rear seat 3 point type inner belt assembly
Significant discoloration on the rear seat 3 point type inner belt assembly
OK:
No defects are found.
HINT
If any of the defects is found, replace the rear seat 3 point type inner belt assembly with a new one.
2. INSPECT REAR SEAT 3 POINT TYPE INNER BELT ASSEMBLY (for Vehicle Involved in Collision and Airbag not Deployed)
(a) Perform a diagnostic system check See: Air Bag Systems/Testing and Inspection/Reading and Clearing Diagnostic Trouble Codes.
(b) Visually check for defects with the rear seat 3 point type inner belt assembly removed from the vehicle.
(1) The defects are as follows:
Cuts on the rear seat 3 point type inner belt assembly
Small cracks on the rear seat 3 point type inner belt assembly
Significant discoloration on the rear seat 3 point type inner belt assembly
Cracks or other damage to the connector
OK:
No defects are found.
HINT
If any of the defects is found, replace the rear seat 3 point type inner belt assembly with a new one.