IS 250C V6-2.5L (4GR-FSE) (2011)
(d) Install the front wiper arm and blade assembly RH with the nut at the position as shown in the illustration.
Torque : 22 Nm (224 kgf-cm, 16 ft-lbf)
HINT
Hold the arm hinge by hand to tighten the nut.
Text in Illustration
(e) Operate the front wipers while spraying washer fluid on the windshield glass. Make sure that the front wipers function properly and there is no
interference with the vehicle body.
6. INSTALL FRONT WIPER ARM HEAD CAP
(a) Install the front wiper arm head cap.
HINT
Use the same procedure for the RH side and LH side.
7. INSTALL FRONT OUTER BODY PILLAR ASSEMBLY LH See: Body and Frame/Exterior Moulding / Trim/Service and Repair/Installation
8. INSTALL ROOF DRIP SIDE FINISH MOULDING LH See: Body and Frame/Exterior Moulding / Trim/Service and Repair/Installation
9. INSTALL FRONT OUTER BODY PILLAR ASSEMBLY RH
HINT
Use the same procedure for the RH side and LH side.
10. INSTALL ROOF DRIP SIDE FINISH MOULDING RH
HINT
Use the same procedure for the RH side and LH side.
11. INSTALL ROOF HEADLINING ASSEMBLY
(a) Install the roof headlining assembly See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Removal and
Replacement/Roof Headlining (for Front Side)/Installation.