IS F V8-5.0L (2UR-GSE) (2008)
(a) Install the generator rear end cover to the generator coil assembly with the 3 nuts.
Torque: 4.6 Nm (47 kgf-cm, 42 in-lbf)
7. INSTALL GENERATOR PULLEY
(a) Install the generator pulley, and temporarily install the pulley lock nut.
(b) Install SST1-A to the pulley shaft.
SST: 09820-63011
09820-06010
09820-06021
(c) Install SST1-B to SST1-A.
(d) While holding SST1-A on the pulley shaft area, tighten SST1-B to the specified torque.
Torque: 39 Nm (400 kgf-cm, 29 ft-lbf)
NOTICE: Securely attach SST1-A to the pulley shaft.
HINT: Read SST1-B tightening torque by using the reactive torque of SST1-A.
(e) Mount 2 faces of SST2 in a vise.
(f) With SST1-A and B attached to the generator, insert the pulley lock nut into the hexagon portion of SST2.
(g) To tighten the generator pulley nut, rotate SST1-A in the direction shown in the illustration.
Torque: 133 Nm (1351 kgf-cm, 98 ft-lbf)
(h) Remove the generator from SST2.