LS 460 V8-4.6L (1UR-FSE) (2007)
/Page-1270014.png)
a. Install the reservoir connector to the No. 2 brake actuator hose with the hose clip as given in the illustration.
Length "A": 4.0 to 7.0 mm (0.158 to 0.276 in.)
b. With the paint mark on the hose's tip facing the bottom of the vehicle, install the No.2 brake actuator hose to the brake accumulator pump with
the hose clip.
NOTE: When inserting the hose, be careful that there is no excessive weight applied to the union of the brake accumulator pump (especially
in the union rotation direction).
HINT: Install the hose clip so that its claws face the rear of the vehicle.
c. Connect the No.2 brake actuator hose to the No.3 brake actuator bracket with the clamp.
7. INSTALL BRAKE ACTUATOR PROTECTOR
