LS 460 V8-4.6L (1UR-FSE) (2007)
10. INSTALL BRAKE ACTUATOR AND BRAKE ACCUMULATOR PUMP ASSEMBLY
a. Install the brake actuator and brake accumulator pump to the body with the bolt (labeled A) and 2 nuts (labeled B).
NOTE:
-
Do not damage the brake tubes.
-
When installing the brake actuator and brake accumulator pump to the vehicle, do not hold the connector, harness, hose or tube parts.
-
Do not drop the brake actuator and brake accumulator pump. Do not use parts that have been dropped.
HINT: First insert the bracket bottom's longer stud bolt (vehicle outer side, labeled C) into the body.
Torque: 20 N.m (204 kgf.cm, 15 ft.lbf)
b. Connect the front fender liner rear side.
c. Connect the No.1 brake actuator hose to the body with the clamp.
d. Connect the 2 brake accumulator pump connectors.
NOTE:
-
Before connecting the vehicle wire harnesses, make sure that the connector faces are free of foreign matter.
-
Make sure that the connectors are locked securely.