LS 460 V8-4.6L (1UR-FSE) (2007)
/Page-659004.png)
d. Install the engine wire bracket with the bolt.
Torque: 10 N.m (102 kgf.cm, 7 ft.lbf)
e. Connect the 2 camshaft timing control motor connectors.
3. INSTALL INTAKE AIR CONNECTOR PIPE
4. INSTALL NO. 1 AIR CLEANER INLET
5. INSTALL AIR CLEANER INLET COVER SUB-ASSEMBLY
6. INSTALL V-BANK COVER SUB-ASSEMBLY
7. REMOVE COWL TOP VENTILATOR LOUVER RH
8. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt
pretensioner activation.
HINT: Disconnect the cable from the from the negative (-) battery terminal so that the maximum retard angle of the camshaft timing control
motor assembly will be learned.
9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
10. INSTALL COWL TOP VENTILATOR LOUVER RH
11. PERFORM INITIALIZATION
a. Perform initialization.
NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.
