LS 460 AWD V8-4.6L (1UR-FSE) (2009)
1UR-FSE ENGINE MECHANICAL: FRONT ENGINE MOUNTING (for AWD): REMOVAL
REMOVAL
1. DISCHARGE FUEL SYSTEM PRESSURE See: Powertrain Management/Fuel Delivery and Air Induction/Fuel Injector/Service and Repair/Fuel
Injector (for Port Injection)/Removal
2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt
pretensioner activation.
NOTE:
After the engine switch is turned off, the HDD navigation system requires approximately 6 minutes to record various types of memory and
settings. As a result, after turning the engine switch off, wait 6 minutes or more before disconnecting the cable from the negative (-) battery
terminal.
3. REMOVE ENGINE AND TRANSMISSION
(a) Remove the engine and transmission See: Service and Repair/Removal and Replacement/Engine/Removal.
4. REMOVE ENGINE OIL LEVEL DIPSTICK GUIDE See: Service and Repair/Removal and Replacement/Engine/Removal
5. REMOVE NO. 1 EXHAUST MANIFOLD HEAT INSULATOR See: Exhaust System/Exhaust Manifold/Service and Repair/Removal
6. REMOVE NO. 2 EXHAUST MANIFOLD HEAT INSULATOR See: Exhaust System/Exhaust Manifold/Service and Repair/Removal
7. REMOVE FRONT FRAME ASSEMBLY See: Service and Repair/Removal and Replacement/Engine/Removal
8. REMOVE FRONT ENGINE MOUNTING INSULATOR
(a) Remove the 2 nuts, 2 spacers and 2 insulators.
Installation
1UR-FSE ENGINE MECHANICAL: FRONT ENGINE MOUNTING (for AWD): INSTALLATION
INSTALLATION
1. INSTALL FRONT ENGINE MOUNTING INSULATOR