LS 460 AWD V8-4.6L (1UR-FSE) (2009)
Suspension Control Module: Service and Repair
Installation
SUSPENSION CONTROL: SUSPENSION CONTROL ECU: INSTALLATION
INSTALLATION
HINT: A bolt without a torque specification is shown in the standard bolt chart See: Specifications/Mechanical Specifications/Standard Bolt -
Specified Torque For Standard Bolts.
1. INSTALL SUSPENSION CONTROL ECU
(a) Install the suspension control ECU to the bracket with the 2 nuts.
Torque: 6.0 Nm (61 kgf-cm, 53 in-lbf)
-
Avoid any impact to the suspension control ECU.
-
Do not drop the ECU. If it is dropped, replace it with a new one.
2. INSTALL SUSPENSION CONTROL ECU WITH BRACKET
(a) Install the ECU with bracket with the nut and bolt.
(b) Connect the ECU connectors.
NOTE:
If the suspension control ECU is replaced with a new one, enter test mode and perform registration of vehicle identification information See:
Steering and Suspension/Suspension/Testing and Inspection/Programming and Relearning.
3. CONNECT CONNECTORS (W/ Clearance Warning ECU)
4. CONNECT CONNECTORS (W/ Parking Assist ECU)
5. INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument
Panel/Service and Repair/Installation
6. INSTALL NO. 2 INSTRUMENT CLUSTER MOULDING See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service
and Repair/Installation
7. INSTALL FRONT PASSENGER SIDE KNEE AIRBAG ASSEMBLY See: Restraint Systems/Air Bag Systems/Air Bag/Service and
Repair/Driver Side Knee Airbag Assembly/Installation
8. INSTALL INSTRUMENT PANEL LOWER See: Restraint Systems/Air Bag Systems/Air Bag/Service and Repair/Front Passenger Side Knee
Airbag Assembly/Installation
9. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY See: Body and Frame/Interior Moulding / Trim/Dashboard /