LS 460 AWD V8-4.6L (1UR-FSE) (2009)
/Page-2596046.png)
(2) After connecting SST each other, connect them to the steering pad.
SST: 09082-00820
(3) Wind 3 wire harnesses at least 2 times each around the bolts installed on the left and right sides of the steering pad.
-
Tightly wind the wire harnesses around the bolts so that there is no slack.
-
Make sure that the wire harnesses are tight. If there is slack in the wire harnesses, the steering pad may become loose due to the
shock when the airbag is deployed.
(4) Face the airbag deployment side of the steering pad upward. Separately tie the left and right sides of the steering pad to the disc wheel
through the hub nut holes. Position the SST connector so that it hangs downward through the hub hole of the disc wheel.
-
Make sure that the wire harnesses are tight. If there is slack in the wire harnesses, the steering pad may become loose due to the
shock when the airbag is deployed.
-
Always tie down the steering pad with the airbag deployment side facing upward.
NOTE:
As the disc wheel may be damaged by the airbag deployment, use a disc wheel that you are planning to throw away.
(d) Install SST.
