LS 460 AWD V8-4.6L (1UR-FSE) (2009)
(2) Check that the ABS warning light and brake warning light / yellow (minor malfunction) blink and "VSC TEST" is indicated on the
multi-information display (Test Mode).
-
If the ABS warning light and brake warning light / yellow (minor malfunction) do not blink and "VSC TEST" is not indicated on the
multi-information display, perform zero point calibration again.
-
The zero point calibration is performed only once after the system enters the Test Mode.
-
Calibration cannot be performed again until the stored data is cleared.
(c) Turn the engine switch off and disconnect the Techstream.
4. CLEAR ZERO POINT CALIBRATION (WHEN USING SST CHECK WIRE)
(a) Turn the engine switch on (IG).
(b) Using SST, connect and disconnect terminals 12 (TS) and 4 (CG) of the DLC3 4 times or more within 8 seconds.
SST: 09843-18040
(c) Check that no codes other than ABS code 42, VSC code 45 and electronically controlled brake system code 48, 66, or 95 are stored in the
diagnostic system.