LS 460 AWD V8-4.6L (1UR-FSE) (2009)
(c) Using SST, disconnect the rear upper No. 1 control arm from the axle carrier.
SST: 09960-20010
09961-02010
NOTICE:
-
Do not damage the dust cover.
-
As the dust cover may be damaged, adjust SST with the center nut so that the body and crow are parallel.
-
Make sure to tie the string of to the vehicle to prevent SST from dropping.
(d) Remove the nut and washer, bolt and control arm from the rear suspension member.
10. REMOVE REAR UPPER NO. 2 CONTROL ARM ASSEMBLY LH
(a) Remove the nut on the rear axle carrier side.
(b) Install 2 spacers (SST spacer A) onto the rear upper No. 2 control arm so that there is a space of approximately 1 mm (0.039 in.) between the
arm and spacers.
SST: 09960-20010
09961-02050
NOTICE:
-
Make sure to install the spacers (SST spacer A) as the axle carrier spacer may shift.
-
As SST may become damaged, make sure the space between the arm and spacers is not 1 mm (0.039 in.) or less.
(c) Using SST, disconnect the rear upper No. 2 control arm from the axle carrier.
SST: 09960-20010
09961-02010
NOTICE:
-
Do not damage the dust cover.
-
As the dust cover may be damaged, adjust SST with the center nut so that the body and crow are parallel.
-
Make sure to tie the string of to the vehicle to prevent SST from dropping.
(d) Remove the nut and washer, bolt and rear control arm from the rear suspension member.
Installation