LS 460 AWD V8-4.6L (1UR-FSE) (2009)
/Page-2366004.png)
terminal.
3. REMOVE LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY See: Body and Frame/Doors, Hood and Trunk/Trunk / Liftgate/Trunk /
Liftgate Spring/Service and Repair/Removal
4. REMOVE ROPE HOOK ASSEMBLY See: Body and Frame/Doors, Hood and Trunk/Trunk / Liftgate/Trunk / Liftgate Spring/Service and
Repair/Removal
5. REMOVE ROPE HOOK See: Body and Frame/Doors, Hood and Trunk/Trunk / Liftgate/Trunk / Liftgate Spring/Service and Repair/Removal
6. REMOVE DECK TRIM SIDE BOARD RH See: Body and Frame/Doors, Hood and Trunk/Trunk / Liftgate/Trunk / Liftgate Spring/Service and
Repair/Removal
7. REMOVE LUGGAGE COMPARTMENT NO. 1 LIGHT ASSEMBLY See: Body and Frame/Doors, Hood and Trunk/Trunk / Liftgate/Trunk /
Liftgate Spring/Service and Repair/Removal
8. REMOVE LUGGAGE COMPARTMENT NO. 2 TRIM HOOK (W/O Rear Cooler) See: Body and Frame/Doors, Hood and Trunk/Trunk /
Liftgate/Trunk / Liftgate Spring/Service and Repair/Removal
9. REMOVE LUGGAGE COMPARTMENT TRIM COVER FRONT See: Body and Frame/Doors, Hood and Trunk/Trunk / Liftgate/Trunk /
Liftgate Spring/Service and Repair/Removal
10. REMOVE REAR FLOOR FINISH PLATE See: Body and Frame/Doors, Hood and Trunk/Trunk / Liftgate/Trunk / Liftgate Spring/Service and
Repair/Removal
11. REMOVE LUGGAGE COMPARTMENT TRIM COVER ASSEMBLY RH See: Body and Frame/Doors, Hood and Trunk/Trunk /
Liftgate/Trunk / Liftgate Spring/Service and Repair/Removal
12. REMOVE ACCELERATION SENSOR ASSEMBLY
(a) Disconnect the connector.
(b) Remove the bolt and sensor with bracket.
NOTICE:
-
Avoid any impact to the suspension control acceleration sensor.
-
Do not drop the acceleration sensor. If it is dropped, replace it with a new one.
-
The acceleration sensor removed from the vehicle must not be placed upside down.
Installation
SUSPENSION CONTROL: REAR ACCELERATION SENSOR: INSTALLATION
INSTALLATION
1. INSTALL ACCELERATION SENSOR ASSEMBLY
(a) Install the acceleration sensor with bracket with the bolt.
Torque: 8.5 Nm (87 kgf-cm, 75 in-lbf)
-
Avoid any impact to the acceleration sensor.
-
Do not drop the acceleration sensor. If it is dropped, replace it with a new one.
(b) Connect the sensor connector.
2. INSTALL LUGGAGE COMPARTMENT TRIM COVER ASSEMBLY RH See: Body and Frame/Doors, Hood and Trunk/Trunk /
Liftgate/Trunk / Liftgate Spring/Service and Repair/Installation
3. INSTALL REAR FLOOR FINISH PLATE See: Body and Frame/Doors, Hood and Trunk/Trunk / Liftgate/Trunk / Liftgate Spring/Service and
Repair/Installation
