LS 460 AWD V8-4.6L (1UR-FSE) (2009)
/Page-2384003.png)
(d) Remove the 2 nuts and height control valve.
Installation
SUSPENSION CONTROL: HEIGHT CONTROL VALVE (for Front Side): INSTALLATION
INSTALLATION
1. INSTALL NO. 1 HEIGHT CONTROL VALVE SUB-ASSEMBLY
(a) Install the height control valve with the 2 nuts.
Torque: 5.4 Nm (55 kgf-cm, 48 in-lbf)
(b) Connect the 3 side air tubes See: Service Precautions/Suspension Control System.
(c) Connect the underside air tube See: Service Precautions/Suspension Control System.
(d) Connect the connector.
2. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
3. INSTALL COWL TOP VENTILATOR LOUVER RH See: Starting and Charging/Charging System/Alternator/Service and Repair/Installation
4. PERFORM INITIALIZATION
(a) Perform initialization See: Testing and Inspection/Programming and Relearning/Repair Instruction - Initialization.
NOTE:
Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.
5. CHECK SRS WARNING LIGHT
(a) Check the SRS warning light See: Restraint Systems/Air Bag Systems/Testing and Inspection/Initial Inspection and Diagnostic
Overview/Diagnosis System.
