LS 460 RWD V8-4.6L (1UR-FSE) (2010)
Evaporative Emission Control Canister: Service and Repair
Installation
1UR-FSE EMISSION CONTROL: CANISTER: INSTALLATION
1. INSTALL CANISTER
(a) Connect the purge line hose to the charcoal canister.
(b) Attach the 2 clamps.
(c) Install the canister with the 4 bolts and 2 plastic nuts.
Torque : 21 Nm (214 kgf-cm, 15 ft-lbf)
(d) Connect the connector (leak detection pump).
(e) Connect the purge line hose to the canister.
(f) Connect the air inlet line tube (leak detection pump) and vent line tube to the pipes of the canister, as shown in A in the illustration. Then slide
the retainers to lock the claws, as shown in B in the illustration.