LS 460 RWD V8-4.6L (1UR-FSE) (2010)
(a) Check the function of SST See: Steering Pad.
(b) Read the precaution See: Service Precautions.
(c) Disconnect the cable from the negative (-) battery terminal.
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt
pretensioner activation.
NOTICE:
*
w/ Navigation System (for HDD):
*
After the engine switch is turned off, the display and navigation module display (HDD navigation system) records various types of
memory and settings. As a result, after turning the engine switch off, be sure to wait for the time specified in the following table
before disconnecting the cable from the negative (-) battery terminal.
Waiting Time before Disconnecting Cable from Negative (-) Battery Terminal:
*
When disconnecting the cable, some systems need to be initialized after the cable is reconnected See: Testing and
Inspection/Programming and Relearning.
(d) Remove the front seat See: Body and Frame/Seats/Service and Repair/Removal and Replacement/Front Seat Assembly/Removal.
HINT
Keep the front seat in the cabin.
(e) Install SST.
(1) Disconnect the connector (yellow colored) from the front seat side airbag.
NOTICE:
When handling the airbag connector, take care not to damage the airbag wire harness.
(2) Connect the SST connector to the front seat side airbag connector.
SST : 09082-00700
SST : 09082-00820
NOTICE:
To avoid damaging the SST connector and wire harness, do not lock the secondary lock of the twin lock.