LS 460 RWD V8-4.6L (1UR-FSE) (2010)
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
NOTICE:
*
w/ Navigation System (for HDD):
*
After the engine switch is turned off, the display and navigation module display (HDD navigation system) records various types of
memory and settings. As a result, after turning the engine switch off, be sure to wait for the time specified in the following table
before disconnecting the cable from the negative (-) battery terminal.
Waiting Time before Disconnecting Cable from Negative (-) Battery Terminal:
*
When disconnecting the cable, some systems need to be initialized after the cable is reconnected See: Testing and
Inspection/Programming and Relearning.
(d) Remove the front seat See: Removal and Replacement/Active Headrest Inflator/Removal.
HINT
Keep the front seat in the cabin.
(e) Install SST.
(1) Disconnect the connector (yellow-colored) from the front seat side airbag.
NOTICE:
When handling the airbag connector, take care not to damage the airbag wire harness.
(2) Connect SST connector to the front seat side airbag connector.
SST : 09082-00700
SST : 09082-00780
NOTICE:
To avoid damaging SST connector and wire harness, do not lock the secondary lock of the twin lock.
(3) Install the front seat See: Removal and Replacement/Active Headrest Inflator/Installation.
(4) Move SST at least 10 m (32.8 ft.) away from the vehicle front side window.
(5) Maintaining enough clearance for SST wire harness in the front side window, close all doors and windows of the vehicle.
NOTICE:
Take care not to damage SST wire harness.
(6) Connect the red clip of SST to the positive (+) battery terminal and the black clip of SST to the negative (-) battery terminal.