LS 460 RWD V8-4.6L (1UR-FSE) (2010)
/Page-2373047.png)
CAUTION:
*
The steering pad becomes extremely hot when the airbag is deployed, so do not touch it for at least 30 minutes after deployment.
*
Use gloves and safety glasses when handling a steering pad with a deployed airbag.
*
Do not apply water to a steering pad with a deployed airbag.
*
Always wash your hands with water after completing the operation.
(1) Remove the steering pad from the disc wheel.
(2) Place the steering pad in a plastic bag, tie it tightly and dispose of it in the same way as other general parts.
Active Headrest Inflator
SUPPLEMENTAL RESTRAINT SYSTEM: ACTIVE HEADREST INFLATOR: DISPOSAL
CAUTION:
Before performing pre-disposal deployment of any SRS part, review and closely follow all applicable environmental and hazardous
material regulations. Predisposal deployment may be considered hazardous material treatment.
1. PRECAUTION
HINT
When scrapping a vehicle equipped with the SRS or disposing of the steering pad, be sure to deploy the airbag first in accordance
with the procedure described below. If any abnormality occurs with the airbag deployment, contact the SERVICE DEPT. of
TOYOTA MOTOR SALES, U.S.A., INC.
CAUTION:
*
Never dispose of a active headrest inflator that has an unactivated airbag.
*
The airbag produces an exploding sound when it is deployed, so perform the operation outdoors and where it will not create a
nuisance to nearby residents.
*
When deploying the airbag, always use the specified SST (SRS Airbag Deployment Tool). Perform the operation in a place away
from electrical noise.
*
When deploying the airbag, perform the operation at least 10 m (32.8 ft.) away from the active headrest inflator.
*
The active headrest inflator becomes extremely hot when the airbag is deployed, so do not touch it for at least 30 minutes after
deployment.
*
Use gloves and safety glasses when handling a active headrest inflator with a deployed airbag.
*
Do not apply water, etc. to a active headrest inflator with a deployed airbag.
*
Always wash your hands with water after completing the operation.
*
An airbag or pretensioner may be activated by static electricity. To prevent this, be sure to touch a metal surface with bare hands
to discharge static electricity before performing this procedure.
2. DISPOSE OF ACTIVE HEADREST INFLATOR (WHEN INSTALLED IN VEHICLE)
HINT
Prepare a battery as the power source to deploy the airbag.
(a) Check the function of SST See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnosis System.
(b) Read the precaution See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnosis System.
(c) Disconnect the cable from the negative (-) battery terminal.
