LS 460 RWD V8-4.6L (1UR-FSE) (2010)
(except 6-Pot Caliper)/Removal
5. REMOVE FRONT DISC BRAKE DUST COVER LH See: Wheel Hub/Service and Repair/Front Axle Hub/Removal
6. DISCONNECT TIE ROD ASSEMBLY LH See: Steering/Steering Gear/Service and Repair/Removal and Replacement/Steering Gear (w/
VGRS)/Removal
7. DISCONNECT FRONT NO. 1 SUSPENSION LOWER ARM ASSEMBLY LH See: Wheel Hub/Service and Repair/Front Axle Hub/Removal
8. DISCONNECT FRONT HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH See: Control Arm/Service and Repair/Front Lower Suspension
Arm/Removal
9. REMOVE FRONT STABILIZER LINK ASSEMBLY LH See: Control Arm/Service and Repair/Front Lower Suspension Arm/Removal
10. DISCONNECT FRONT NO. 2 SUSPENSION LOWER ARM ASSEMBLY LH See: Front Shock Absorber (w/ Air Suspension)/Removal
11. REMOVE AIR CLEANER INLET COVER SUB-ASSEMBLY
12. REMOVE ENGINE ROOM SIDE COVER LH See: Engine, Cooling and Exhaust/Engine/Service and Repair/Removal and
Replacement/Engine/Removal
13. REMOVE FRONT SHOCK ABSORBER ASSEMBLY LH
(a) Loosen the lock nut of the front shock absorber.
NOTICE:
*
Do not remove the lock nut.
*
Loosen the lock nut only when disassembling the front shock absorber with coil spring.
(b) Remove the 3 nuts from the upper side of the front suspension support.
(c) Slowly lower the jack. Remove the bolt from the lower side to remove the front shock absorber with coil spring.
Installation
SUSPENSION: FRONT SHOCK ABSORBER: INSTALLATION
1. INSTALL FRONT SHOCK ABSORBER ASSEMBLY LH
(a) Install the front shock absorber on the vehicle by installing the 3 nuts on the suspension support side.
Torque : 67 Nm (683 kgf-cm, 49 ft-lbf)