LS 460 RWD V8-4.6L (1UR-FSE) (2010)
(b) Tighten the lock nut.
Torque : 28 Nm (280 kgf-cm, 20 ft-lbf)
2. INSTALL ENGINE ROOM SIDE COVER LH See: Engine, Cooling and Exhaust/Engine/Service and Repair/Removal and
Replacement/Engine/Installation
3. INSTALL AIR CLEANER INLET COVER SUB-ASSEMBLY
4. TEMPORARILY TIGHTEN FRONT NO. 2 SUSPENSION LOWER ARM ASSEMBLY LH See: Front Shock Absorber (w/ Air
Suspension)/Installation
5. INSTALL FRONT STABILIZER LINK ASSEMBLY LH See: Control Arm/Service and Repair/Front Lower Suspension Arm/Installation
6. CONNECT FRONT HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH See: Control Arm/Service and Repair/Front Lower Suspension
Arm/Installation
7. INSTALL FRONT NO. 1 SUSPENSION LOWER ARM ASSEMBLY LH See: Wheel Hub/Service and Repair/Front Axle Hub/Installation
8. CONNECT TIE ROD ASSEMBLY LH See: Steering/Steering Gear/Service and Repair/Removal and Replacement/Steering Gear (w/
VGRS)/Installation
9. INSTALL FRONT DISC BRAKE DUST COVER LH See: Wheel Hub/Service and Repair/Front Axle Hub/Installation
10. INSTALL FRONT DISC See: Brakes and Traction Control/Disc Brake System/Service and Repair/Removal and Replacement/Front Brake
(except 6-Pot Caliper)/Installation
11. CONNECT FRONT DISC BRAKE CALIPER ASSEMBLY LH See: Wheel Hub/Service and Repair/Front Axle Hub/Installation
12. CONNECT SPEED SENSOR CONNECTOR See: Wheel Hub/Service and Repair/Front Axle Hub/Installation
13. STABILIZE SUSPENSION
(a) Install the front tires.
Torque : 140 Nm (1428 kgf-cm, 103 ft-lbf)
(b) Lower the vehicle and bounce it up and down several times to stabilize the front suspension.
(c) Remove the front tires.
(d) Jack up the front suspension lower arm with a wooden block between the jack and front suspension lower arm. Apply a load to the front
suspension so that the front suspension lower arm is placed in a horizontal position.