LS 460 RWD V8-4.6L (1UR-FSE) (2010)
23. REMOVE LOAD SENSING VALVE SENSOR BRACKET See: Sensors and Switches - Suspension/Ride Height Sensor/Service and
Repair/Height Control Sensor (for Rear LH)/Removal
24. DISCONNECT REAR UPPER NO. 2 CONTROL ARM ASSEMBLY LH See: Wheel Hub/Service and Repair/Rear Axle Hub/Removal
25. DISCONNECT REAR UPPER NO. 1 CONTROL ARM ASSEMBLY LH See: Wheel Hub/Service and Repair/Rear Axle Hub/Removal
26. DISCONNECT TOE CONTROL LINK SUB-ASSEMBLY LH See: Wheel Hub/Service and Repair/Rear Axle Hub/Removal
27. REMOVE REAR AXLE SHAFT LH NUT See: Wheel Hub/Service and Repair/Rear Axle Hub/Removal
28. REMOVE REAR SHOCK ABSORBER CAP LH
(a) Remove the 3 nuts and cap.
29. REMOVE REAR SHOCK ABSORBER ASSEMBLY LH
(a) Remove the 3 nuts on the upper side of the shock absorber.
(b) Remove the nut from the shock absorber lower side.
(c) Angle the axle carrier's upper tip toward the vehicle's outer side, and remove the shock absorber.
Installation
SUSPENSION: REAR SHOCK ABSORBER: INSTALLATION
HINT
*
Use the same procedures for the RH side and LH side.
*
The procedures listed below are for the LH side.
*
A bolt without a torque specification is shown in the standard bolt chart See: Specifications/Mechanical Specifications/Standard
Bolt - Specified Torque For Standard Bolts.
1. TEMPORARILY INSTALL REAR SHOCK ABSORBER ASSEMBLY LH