LS 460 RWD V8-4.6L (1UR-FSE) (2010)
(a) Install the rear shock absorber on the vehicle by installing the 3 nuts on the suspension support side.
Torque : 64 Nm (653 kgf-cm, 47 ft-lbf)
NOTICE:
When installing the shock absorber, make sure the lower coil spring bottom tip is on the vehicle's front side.
(b) Temporarily install the rear shock absorber lower side with a new nut and washer to the axle carrier.
(c) Tighten the new lock nut.
Torque : 27 Nm (275 kgf-cm, 20 ft-lbf)
2. INSTALL REAR SHOCK ABSORBER CAP LH
(a) Install the cap with the 3 nuts to the shock absorber.
Torque : 14 Nm (143 kgf-cm, 10 ft-lbf)
3. CONNECT TOE CONTROL LINK SUB-ASSEMBLY LH See: Wheel Hub/Service and Repair/Rear Axle Hub/Installation
4. CONNECT REAR UPPER NO. 2 CONTROL ARM ASSEMBLY LH See: Wheel Hub/Service and Repair/Rear Axle Hub/Installation
5. CONNECT REAR UPPER NO. 1 CONTROL ARM ASSEMBLY LH See: Wheel Hub/Service and Repair/Rear Axle Hub/Installation
6. STAKE REAR AXLE SHAFT LH NUT See: Wheel Hub/Service and Repair/Rear Axle Hub/Installation
7. INSTALL LOAD SENSING VALVE SENSOR BRACKET See: Sensors and Switches - Suspension/Ride Height Sensor/Service and
Repair/Height Control Sensor (for Rear LH)/Installation
8. INSTALL REAR SPEED SENSOR LH See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Wheel Speed
Sensor/Service and Repair/Rear Speed Sensor/Removal
9. INSTALL PACKAGE TRAY TRIM PANEL ASSEMBLY See: Windows and Glass/Windows/Window Shade/Service and Repair/Rear
Sunshade Assembly/Installation