RX 330 AWD V6-3.3L (3MZ-FE) (2004)
HINT: If the cover is damaged, exchange it for a new cover.
b. Using a screwdriver, pry out the nut cap.
HINT: Tape the screwdriver tip before use.
NOTE: Removing the nut cap damages the clips inside the nut cap. Therefore, the use of a new nut cap is necessary for installation.
c. Remove the 3 bolts and hood lock.
d. Disconnect the connector.
e. Remove the cable.
12. INSTALL HOOD LOCK ASSEMBLY
a. Install the cable.
b. Connect the connector.
c. Install the hood lock with the 3 bolts.
Torque: 8.0 Nm (82 kgf.cm, 10 in.lbf)
d. Adjust the hood lock position.
e. Install the cap nut.
f.
Install the hood lock control cable cover.