RX 330 AWD V6-3.3L (3MZ-FE) (2004)
/Page-1776004.png)
17.
Remove Sliding Roof Housing Center Frame
A.
Remove the 12 nuts and center frame.
18.
Remove Sliding Roof Drive Cable LH
A.
Pull out the drive cable.
19.
Remove Sliding Roof Drive Cable RH
A.
Pull out the drive cable.
20.
Install New Drive Rail Sub-Assembly to Sliding Roof Housing Panel.
NOTE:
As the housing is very heavy, work must be done by 2 or more persons together.
A.
Install the sliding roof drive cables RH and LH to the sliding roof housing panel.
B.
Temporarily tighten the 16 mounting screws and 14 nuts for the sliding roof housing panel.
C.
Completely tighten the 16 mounting screws and 14 nuts for the sliding roof housing panel, and the 12 mounting nuts for the roof center
frame.
D.
After the sliding roof housing panel is completely tightened, pass the sliding roof cable guide casing through the frames of the sliding roof
drive cables RH and LH.
