RX 330 AWD V6-3.3L (3MZ-FE) (2004)
Roof Rack Frame: All Technical Service Bulletins
Body - Roof Rack Cross Bars Hard to Position
BODY
BO011-03
REVISED
Title:
ROOF RACK CROSS BAR RELEASE
LEVER IMPROVEMENT
Models:
'04 RX 330
December 2, 2003
TSIB REVISION NOTICE:
January 12, 2004: The Op Code in Warranty Information has been updated.
The previous TSIB should be discarded.
Introduction
Some customers may not be able to adjust the position of their roof rack cross bars on the 2004 model year RX 330 vehicles. The release lever has been
changed to a more robust design. Please replace with the updated part number below to correct this condition.
Applicable Vehicles
^
2004 model year RX 330 vehicles.
Parts Information
Repair Procedure
1.
Grab from the sides and lift up from the center to remove the rear roof rack end caps. Unscrew and remove the retaining screw on each rail.
2.
Remove the affected roof rack through the back of the rails.
3.
Install the new cross bars facing the correct direction and reassemble end caps.