RX 330 AWD V6-3.3L (3MZ-FE) (2004)
/Page-326003.png)
6. INSPECT CAMBER, CASTER AND STEERING AXIS INCLINATION
a. Put the front wheel on the center of the alignment tester.
b. Set the camber -caster- kingpin gauge at the center of the axle hub or drive shaft.
Camber, caster and steering axis inclination
Except air suspension
Air suspension
If the caster and steering axis inclination are not within the specified values after the camber has been correctly adjusted, recheck the
suspension parts for damage and/or wear.
7. ADJUST CAMBER
NOTICE: After the camber has been adjusted, inspect the toe-in.
a. Remove the front wheel.
b. Remove the 2 nuts on the lower side of the shock absorber.
NOTICE: When removing the nuts, keep the bolts from rotating.
