RX 330 AWD V6-3.3L (3MZ-FE) (2004)
c. Clean the installation surface of the shock absorber and the steering knuckle.
d. Temporarily install the 2 nuts.
e. Adjust the camber by pushing or pulling the lower side of the shock absorber in the direction in which camber adjustment is required.
f.
Tighten the nuts.
Torque: 230 Nm (2,350 kgf-cm, 170 ft. lbs.)
NOTICE: When installing the nuts, keep the bolts from rotating and them torque the nuts.
g. Install the front wheel.
Torque: 103 Nm (1,050 kgf-cm, 76 ft. lbs.)
h. Check the camber.
HINT:
^
Try to adjust the camber to the center of the specified value.
^
Adjusting value for the set bolts is 6' to 30' (0.1° to 0.5°). If the camber is not within the specified value, estimate how much additional
camber adjustment will be required, and select the camber adjusting bolt.
NOTICE: Tighten the adjusting bolt with a new nut.