RX 330 AWD V6-3.3L (3MZ-FE) (2004)
b. Remove the nut, and disconnect the stabilizer link from the shock absorber.
HINT: If the ball joint turns together with the nut, use a hexagon wrench (5 mm) to hold the stud
4. SEPARATE HEIGHT CONTROL SENSOR SUB-ASSY REAR LH
5. REMOVE PNEUMATIC REAR LH W/SHOCK ABSORBER CYLINDER ASSY
a. Disconnect the connector No.2.
b. Using SST(s), remove the height control tube No 7 from the pneumatic shock absorber.
SST 09730-00010
c. 2WD models: Disconnect the skid control sensor connector. Remove the 2 bolts, and disconnect the flexible hose and skid control sensor wire
from the pneumatic shock absorber.
d. 4WD models: Remove the 3 bolts, and disconnect the flexible hose and speed sensor from the pneumatic shock absorber and rear axle carrier.