RX 330 AWD V6-3.3L (3MZ-FE) (2004)
/Page-1381005.png)
e. Loosen the 2 nuts on the lower side of the pneumatic shock absorber.
HINT: Do not remove the 2 bolts and 2 nuts.
f.
Remove the 3 nuts.
g. Lower the rear axle carrier, and remove the 2 nuts and bolts on the lower side of the pneumatic shock absorber.
h. Remove the pneumatic shock absorber.
6. INSPECT PNEUMATIC REAR LH W/SHOCK ABSORBER CYLINDER ASSY
a. Compress and extend the pneumatic shock absorber, and check that there is no abnormal resistance or unusual sound.
If there is any abnormality, replace the pneumatic shock absorber with a new one.
NOTICE:
^
Be sure not to cover the connection part of the height control tube No.7 when compressing and expanding the pneumatic shock absorber.
^
Do not touch the dust cover as much as possible in order not to deform it.
^
When disposing of the pneumatic shock absorber, see DISPOSAL.
7. INSTALL PNEUMATIC REAR LH W/SHOCK ABSORBER CYLINDER ASSY
a. Coat a new O-ring with MP grease, and install it to the pneumatic shock absorber.
HINT:
^
For disconnection and connection of the O-ring and tube, see Suspension Control (Automatic - Electronic Level); Service Precautions;
Vehicle Damage Warnings.
^
When replacing the pneumatic cylinder assembly, it is unnecessary to replace the O-ring with a new one.
