RX 350 FWD V6-3.5L (2GR-FE) (2010)
Evaporator Temperature Sensor / Switch: Service and Repair
Installation
Up to 08/2009
HEATING / AIR CONDITIONING: FRONT EVAPORATOR TEMPERATURE SENSOR: INSTALLATION
1. INSTALL NO. 1 COOLER THERMISTOR
(a) Install the No. 1 cooler thermistor as shown in the illustration.
Text in Illustration
NOTICE:
*
Be sure to insert the thermistor only once because reinserting it into the same position will not allow it to be firmly secured.
*
When reusing the evaporator, insert the thermistor one row next to the one that has been used previously (X in the illustration).
*
After inserting the thermistor, do not apply excessive force to the wire.
*
Directly insert the thermistor until the edge of plastic case "a" comes into contact with evaporator "b".
2. INSTALL COOLER EVAPORATOR SUB-ASSEMBLY (for TMC Made) See: Housing Assembly HVAC/Service and
Repair/Overhaul/Reassembly
3. INSTALL COOLER EVAPORATOR SUB-ASSEMBLY (for TMMC Made) See: Housing Assembly HVAC/Service and
Repair/Overhaul/Reassembly
4. INSTALL BLOWER ASSEMBLY (for TMMC Made) See: Blower Motor/Service and Repair/Removal and Replacement/Blower
Unit/Installation
5. INSTALL COOLER EXPANSION VALVE (for TMC Made) See: Housing Assembly HVAC/Service and Repair/Overhaul/Reassembly
6. INSTALL COOLER EXPANSION VALVE (for TMMC Made) See: Housing Assembly HVAC/Service and Repair/Overhaul/Reassembly
7. INSTALL AIR CONDITIONING RADIATOR ASSEMBLY (for TMC Made) See: Housing Assembly HVAC/Service and
Repair/Overhaul/Reassembly
8. INSTALL AIR CONDITIONING HARNESS ASSEMBLY (for TMC Made) See: Housing Assembly HVAC/Service and
Repair/Overhaul/Reassembly
9. INSTALL AIR CONDITIONING HARNESS ASSEMBLY (for TMMC Made) See: Housing Assembly HVAC/Service and
Repair/Overhaul/Reassembly