RX 350 FWD V6-3.5L (2GR-FE) (2010)
(a) Inspect and adjust fog light aiming See: Lighting and Horns/Fog/Driving Lamp/Adjustments.
12. PERFORM DIAGNOSTIC SYSTEM CHECK
(a) Perform a diagnostic system check See: Air Bag Systems/Testing and Inspection/Reading and Clearing Diagnostic Trouble Codes/DTC
Check / Clear.
13. INSPECT SRS WARNING LIGHT
(a) Inspect the SRS warning light See: Air Bag Systems/Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnosis System.
From 08/2009
SUPPLEMENTAL RESTRAINT SYSTEMS: FRONT AIRBAG SENSOR: INSTALLATION
HINT
*
Use the same procedure for the RH side and LH side.
*
The procedure listed below is for the LH side.
1. INSTALL FRONT AIRBAG SENSOR
(a) Check that the engine switch is off.
(b) Check that the cable is disconnected from the negative (-) battery terminal.
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
(c) Engage the 2 claws and pin (stopper) into the body hole.
(d) Install the front airbag sensor with the 2 bolts.
Torque : 9.0 Nm (92 kgf-cm, 80 in-lbf)
NOTICE:
*
If the front airbag sensor has been dropped, or there are any cracks, dents or other defects in the case or connector, replace it with
a new one.
*
When installing the front airbag sensor, be careful that the SRS wiring does not interfere with or is not pinched between other
parts.
*
Make sure that the pin (stopper) is securely inserted into the body hole.
*
Tighten the bolt while holding the front airbag sensor because the front airbag sensor pin (stopper) is easily damaged.
(e) Connect the connector to the front airbag sensor.
NOTICE:
When connecting the airbag connector, take care not to damage the airbag wire harness.
(1) Before connecting the connector, check that the position of the white housing lock is correct as shown in the illustration.