RX 350 FWD V6-3.5L (2GR-FE) (2010)
(2) Be sure to engage the connectors until they are locked (when locking, make sure that a click sound can be heard).
HINT
When engaged, the white housing lock will slide. Be sure not to hold the white housing lock and part (A), as it may result in an
insecure fit.
(f) Check that there is no looseness in the installation parts of the front airbag sensor.
2. INSTALL HEADLIGHT ASSEMBLY See: Lighting and Horns/Headlamp/Service and Repair/Removal and Replacement/Installation
3. INSTALL FRONT BUMPER ASSEMBLY See: Body and Frame/Bumper/Front Bumper/Service and Repair/Removal and
Replacement/Installation
4. INSTALL HOOD CENTER CUSHION See: Body and Frame/Bumper/Front Bumper/Service and Repair/Removal and Replacement/Installation
5. INSTALL COOL AIR INTAKE DUCT SEAL See: Body and Frame/Bumper/Front Bumper/Service and Repair/Removal and
Replacement/Installation
6. INSTALL ENGINE ROOM SIDE COVER See: Body and Frame/Bumper/Front Bumper/Service and Repair/Removal and
Replacement/Installation
7. INSTALL ENGINE ROOM SIDE COVER LH See: Body and Frame/Bumper/Front Bumper/Service and Repair/Removal and
Replacement/Installation
8. ADD WASHER FLUID (w/ Headlight Cleaner System) See: Wiper and Washer Systems/Windshield Washer Motor/Service and Repair/Washer
Motor (for Front Side)/Installation
9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected See: Testing and
Inspection/Programming and Relearning/Repair Instruction - Initialization.
10. INSPECT AND ADJUST HEADLIGHT AIMING
(a) Inspect and adjust headlight aiming See: Lighting and Horns/Headlamp/Adjustments.
11. INSPECT AND ADJUST FOG LIGHT AIMING