Continental V8-4.6L DOHC (1995)
4. If results of Circuit 914 (+) = 0000 and Circuit 915 (-) = 0000, then the Multiplex Communication Network link test passed.
If non-zeros returned, then refer to Failed Module Look-up Table to continue diagnosis.
On-Demand Self-Test
On-Demand Self-Test
NOTE: This test is used to verify operation of module currently being tested.
1. Perform New Generation Star Tester Hookup and Vehicle Selection as specified. See: Displaying and Reading Trouble Codes/New Generation
Star Tester Usage/New Generation Star Tester Hookup and Vehicle Selection
2. NOTE: The ignition switch must be in RUN position or test will fail.
Rotate dial to menu item "Diagnostic Data Link" and press trigger.
3. Select module to test by rotating dial to highlight module and press trigger.
4. Menu item "Diagnostic Test Modes" is highlighted. Press trigger.
5. Rotate dial to highlight menu item "On-Demand Self Test." Press trigger, then press start (Button 3).
6. Prepare the vehicle for entry condition as specified for each module - press trigger.
Retrieve/Clear Continuous DTCS
Retrieve/Clear Continuous DTC's
1. Perform New Generation Star Tester Hookup and Vehicle Selection as specified. See: Displaying and Reading Trouble Codes/New Generation
Star Tester Usage/New Generation Star Tester Hookup and Vehicle Selection
2. NOTE: The ignition switch must be in RUN position or test will fail.
Rotate dial to menu item "Diagnostic Data Link" and press trigger.
3. Select module to test by rotating dial to highlight module and press trigger.
4. Menu item "Diagnostic Test Modes" is highlighted. Press trigger.
5. Rotate dial to menu item "Retrieve/Clear Continuous DTC", press trigger, then press start (Button 3).
6. Clear individual DTC (not supported by anti-lock brake system) from selected module, highlight DTC by rotating dial then press Button 8.
7. Clear all DTC's from selected module, press Button 7.
Retrieve PID Information
Retrieve PID Information
1. NOTE: This test is used to verify operation of input circuitry to the module being tested. The ignition switch must be in RUN position or test will
fail.
Perform New Generation Star Tester hookup and vehicle selection as specified. See: Displaying and Reading Trouble Codes/New Generation Star
Tester Usage/New Generation Star Tester Hookup and Vehicle Selection
2. Rotate dial to menu item "Diagnostic Data Link" and press trigger.
3. Select module by rotating dial to highlight module and press trigger.
4. Rotate dial to highlight menu item "PID/Data Monitor and Record", press trigger.
5. Select PID acronyms by rotating dial to highlight a PID and then press trigger. Repeat this process until all PIDs are selected. (* - indicates that a
PID has been selected.)
6. Press Button 7 to view all selected PIDs.
