Mark VII V8-302 5.0L VIN F FI (1987)
b. Once again, torque the lower intake manifold bolts in sequence to 23-25 lb.ft. (32-34 N-m).
Customer Oil Consumption Test
NOTE:
SEE THE WARRANTY AND POLICY MANUAL FOR APPLICABLE CHARGES.
1. Drain the engine oil and remove the oil filter.
2. Install a new FL1-A oil filter.
3. Install five (5) quarts of Ford XO-10W30-QP engine oil in passenger cars and six (6) quarts in light truck applications. An equivalent oil can be used
as long as it meets Ford specification ESE-M2C153-E and API SG.
4. Make sure the vehicle has the correct dipstick. Check the enginnering part number stamped on the dip stick against the information provided in the
dip stick application chart that follows.
5. Run the engine for two (2) minutes then turn the engine off.
6. Let the oil drain back into the oil pan for at least three (3) minutes before going to Step 7.
7. With the engine off and the vehicle parked on level ground, remove the engine oil dip stick and wipe it clean. Fully re-install the dip stick, then
remove it again.