Navigator 4WD V8-5.4L (2010)
5. Remove the outboard latch-to-cushion frame bolt and the outboard latch.
-
To install, tighten to 30 Nm (22 lb-ft).
6. Remove the 6 screws and the backrest support panel.
7. To assemble, reverse the disassembly procedure.
Seat Backrest - Third Row, 60 Percent
Seat Backrest - Third Row, 60 Percent
Disassembly and Assembly
NOTE: For parts identification and locations, refer to Seat - Exploded View, Third Row See: Service and Repair/Rear Seat/Seat - Exploded View,
Third Row.
1. Remove the seat backrest cover. For additional information, refer to Seat Backrest Cover - Third Row See: Seat Cover/Service and Repair/Rear
Seat/Seat Backrest Cover - Third Row.
2. Remove the safety belt anchor bolt.
-
To install, tighten to 40 Nm (30 lb-ft).
3. Remove the backrest foam pad.
4. Remove the nut, screw and support bracket.
5. Remove the outboard latch-to-cushion frame bolt and outboard latch.
-
To install, tighten to 35 Nm (26 lb-ft).
6. Remove the 2 inboard latch-to-backrest frame bolts and inboard latch.
-
To install, tighten to 55 Nm (41 lb-ft).
7. Remove the 4 screws and safety belt retractor cover.
8. Remove the safety belt retractor bolt.
-
To install, tighten to 40 Nm (30 lb-ft).
9. Pinch to release the safety belt guide and remove the safety belt retractor.
-
Route through the backrest frame.
10. Remove the 15 screws and backrest support panel.
11. Remove the bolt and child safety seat tether anchor.
-
To install, tighten to 15 Nm (133 lb-in).
12. To assemble, reverse the disassembly procedure.
