Navigator 4WD V8-5.4L (2010)
12. Disconnect the 2 transmission fluid cooler-to-radiator hoses.
13. NOTE: The cooling module must be positioned rearward to raise and detach the 4 condenser mounts from the radiator.
Depress the retaining tabs on the 2 lower condenser mounting brackets and raise the condenser assembly until the 4 condenser mounting brackets
detach from the radiator.
14. Remove the radiator.
15. To install, reverse the removal procedure.
16. Fill and bleed the cooling system. For additional information, refer to Cooling System Draining, Filling and Bleeding See: Service and
Repair/Cooling System Draining, Filling and Bleeding.
17. Carry out the transmission fluid level check. For additional information, refer to Automatic Transmission/Transaxle &/or Transmission Control
Systems. See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Service and Repair/Procedures/Transmission Fluid Level Check
