Navigator 4WD V8-5.4L (2010)
13. Remove the selector lever cable clip to release the selector lever cable from the selector lever cable bracket.
14. Remove the bolts and the selector lever cable bracket from the transmission.
Installation
All vehicles
1. Install the selector lever cable bracket and bolts onto the transmission.
-
Tighten to 25 Nm (18 lb-ft).
2. NOTICE: To prevent selector lever cable damage, do not apply force to the selector lever cable between the manual control lever and the
selector lever cable bracket.
NOTE: When installing the selector lever cable, make sure that the selector lever cable locking tabs are locked in place. Press the selector lever
cable into the selector lever cable bracket and listen for the selector lever cable to click into place. Pull back on the selector lever cable to make
sure that the selector lever is locked into the selector lever cable bracket.
Install the selector lever cable into the selector lever cable bracket.
3. NOTE: When installing the selector lever cable end, make sure that the selector lever cable end is securely installed onto the manual control lever.
Pull back on the selector lever cable to make sure that the selector cable end is securely installed onto the manual control lever.
Connect the selector lever cable onto the manual control lever.
-
Listen for the audible click.
-
Pull back on the selector lever cable to make sure that it is securely installed.
