Navigator 4WD V8-5.4L (2010)
8. Install the console upper trim and the screw.
9. Install the selector lever trim ring, console tray and cup holder insert.
Navigator
10. NOTE: When installing the selector lever cable, make sure that the selector lever cable locking tabs are locked in place. Press the selector lever
cable into the bracket and listen for the selector lever cable to click into place. Pull back on the selector lever cable to make sure that it is locked
into the bracket.
Connect the selector lever cable onto the selector lever housing.
11. Install the center console LH finish panel.
12. NOTE: When installing the selector lever cable end, make sure that the selector lever cable end is securely installed onto the selector lever ball
stud. Pull back on the selector lever cable to make sure that the selector cable end is securely installed onto the selector lever ball stud.
NOTE: The selector lever bezel has been removed from art for clarity. Do not remove the selector lever bezel.
Connect the selector lever cable onto the selector lever arm.
-
Listen for the audible click.