Navigator 4WD V8-5.4L DOHC VIN R (2001)
^
Place a third jack stand under the front of the differential housing. The front of the differential housing must point slightly upward to allow the
control arms to clear the rear axle when lowering the vehicle.
2. Lower the vehicle slightly and install both rear springs.
3. CAUTION: Constantly check that the rear springs seat correctly.
Gradually lower the vehicle onto the axle.
^
Watch for obstructions.
4. NOTE: Position the rear disc brake caliper and brake line before installing the bolt and nut.
Position the rear suspension upper front arm and bushing and install the bolt and nut.
^
Repeat for the other side.
5. Position the rear suspension arm and bushing and install the bolt and nut.
^
Repeat for the other side.
