Town Car V8-4.6L VIN V Flex Fuel (2006)
Power Seat Motor: Service and Repair
Front Seat Track Motor
FRONT SEAT TRACK MOTOR
Removal
WARNING:
-
Always wear safety glasses when repairing a supplemental restraint system (SRS) vehicle and when handling an air bag module. This will
reduce the risk of injury in the event of an accidental deployment.
-
Never probe the connectors on the air bag module. Doing so can result in air bag deployment, which can result in personal injury.
-
To reduce the risk of personal injury, do not use any memory saver devices.
-
The tightening torque of the seat track fasteners is critical for proper seat track system operation. Failure to follow these instructions may
result in the failure of the seat to perform as designed with resultant risk of personal injury to the vehicle occupant.
NOTE:
-
If a seat equipped with a supplemental restraint system (SRS) component is being serviced, the SRS must be depowered.
-
The air bag warning lamp illuminates when the RCM fuse is removed and the ignition switch is ON. This is normal operation and does not indicate
a supplemental restraint system (SRS) fault.
-
The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
-
Wear protective gloves as needed when handling components or parts that have pointed or sharp edges.
1. Move the seat so the front and rear vertical motors are positioned in the middle of their travel.
2. NOTE: If the seat does not move while activating the seat control switch, push on the seat cushion in the direction needed while activating the
switch.
If the seat cannot be moved, a new seat track assembly must be installed.
Move the seat horizontally to access all seat-to-floor fasteners.
3. Depower the supplemental restraint system (SRS).
4. Remove the seat.
5. Remove the seat track.
6. Disconnect the seat track motor electrical connector. To change the seat track horizontal position, apply power and ground to the pins shown.
