Town Car V8-4.6L VIN V Flex Fuel (2006)
8. Remove the cowl bolt.
9. Disconnect the vapor management valve (VMV) electrical connector.
10. Disconnect the 2 VMV fittings.
11. Remove the 2 upper vapor management valve nuts.
-
To install, tighten to 6 Nm (53 lb-in).
12. Remove the 5 RH cowl extension screws and the RH cowl extension.
13. Remove the lower VMV nut and the VMV.
14. Disconnect the evaporator core housing harness electrical connector.
15. Release the 2 heater outlet hose clamps and remove the heater outlet hose.
16. Release the heater inlet hose clamp and disconnect the heater inlet hose from the heater core.
17. Remove heater tube bracket nut and stud at the rear of the engine.
-
To install, tighten to 12 Nm (9 lb-ft).
18. Remove the bolt and position the windshield washer fluid reservoir aside.
